The Batch Pasteurizer will be triple walled. The inner shell faricated
from stainless steel 304 Quality sheet. Sufficient insulation will
be provided to ensure no heat loss. One reduction gear box attached
with electric motor fitted on the top. Agitator with shaft and blade
will be provided on the top.
...................... Same as above in 500 Ltrs
...................... Same as above in 250 Ltrs
...................... Same as above in 100 Ltrs
... Same as above in 40 Ltrs
BATCH TYPE MILK BOTTLE STERILIZER
Batch Milk Sterilization unit made of 6 mm M.S Sheet rolled welded
construction, horizontal with M.S Frame for placing bottle Crate
Cap. 480 x 200 mi bottle per batch. The sterilizer is supplied with
quick closing/ opening screw type door and steam spraying device
on the top and bottom. It is supported on four MS Pipe for floor
mounting. The following Accessories supplied with sterilizer: 1
No. Steam Trap
1 No. Pressure Gauge
1 No. Safety Valve
1 No. Blow off Cock
1 No. Dial Thermometer
PASTEURIZATION UNIT CONTINUOUS MSMP 900 LPH
The plate pasteurization unit is well suited for pasteurization
1. Balance Tank is stainless steel, inside and outside polished,
equipped with S.S. Float and loose cover.
2. Stainless steel centrifugal pump for product, complete with electrical
3. Plate heat exchanger with frame cladded with stainless steel.
The plate pack is clamped between frame head and follower by means
of stainless steel tie bars placed along the edge of the frame.
4. External Holding time: 20 seconds.
5. Stainless steel electrical water heating set
6. Set of temperature regulating equipment consisting of Control
panel for controlling and recording of the pasteurization and outlet
7. Set of internal stainless steel pipes, fittings and base frame
or mounting of the equipment.
The equipment is assembled on base frame and tested in our factory.